TECHNICAL SPECIFICATIONS
- Selectable Current:350-1050mA
- DC voltage range:2-100V
- Rated Power:26~40W
- Ripple Current:±5%
- Ripple & Noise(max.):700mVp-p
- No-load Output Voltage(max.):110V
- Current Accuracy:±5%
- Setup, Rise Time:500ms, 80ms / 230VAC at rated power
- Hold Up Time:16ms/230VAC at rated power
- Voltage Range: 180 ~ 295VAC 254 ~ 417VDC
- Frequency Range:47 ~ 63Hz
- Power Factor(Typ.):PF≧0.975/230VAC, PF≧0.96/277VAC at rated power
- Total Harmonic Distortion:THD will be lower than 20% when output loading is 75% or higher
- Efficiency(Typ.):91%
- AC Current(Typ.):0.23A/230VAC
- Inrush Current(Typ.)COLD START 20A(twidth=260μs measured at 50% Ipeak) at 230VAC
- Leakage Current:<0.5mA / 240VAC
- Short Circuit:Constant current limiting, recovers automatically after fault is removed
- Over Voltage:110 ~ 130V
- Over Temperature:Shut down o/p voltage, re-power on to recover
- Auxiliary Power(optional):12V @ 50mA for driving fan; Tolerance ±5%
- Temp.Compensation:By external NTC(not provide with the power supply)
- Working Temp.:-30 ~ +60℃ (Refer to "Derating Curve")
- Working Humidity: 20 ~ 90% RH non-condensing
- Storage Temp.,Humidity:-40 ~ +80℃, 10 ~ 95% RH
- Safety Standards:UL8750, ENEC, GB19510.14,GB19510.1 approved
- DALI Standards:Comply with IEC62386-101, 102, 207
- Withstand Voltage.:I/P-O/P:3.75KVAC
- EMC Emission:Compliance to ENEC;Class C;GB17625.1,GB17743
DIP Switch Table of Dali dimmable panel light
Dali dimmable panel light is a multiple-stage output current supply, selection of output current through DIP switch as table below.
Power Factor Characteristic
Dimming Operation
‧Maximum number of drivers up to 10 pcs.
‧Maximum length of the cable, from push button to last driver is 20 meter.
‧Factory setting at 100%.
‧When the light is lower than 10% it will always dim up, or when the light output is higher than 90% it will always dim down.
Warning:
The pushbutton can only be connected in between the PUSH terminal of Driver and AC/L (brown or black color). It would cause short circuit if it is connected to AC/N.
※DALI interface(primary side)
‧DALI protocol including 16 groups and 64 addresses.
‧First step is fixed at 6% of output.
Synchronization Synchronization
‧10 drivers(max.) synchronization (1 master + 9 slaves)
‧Maximum cable length between each units : 20 meter.
NOTE: Please make sure all units are set to 100% dimming setting(factory default) before synchronizing.
Electrical Connection
Dali dimmable led panel light Description
TheDali led panel lightconsists of the led panel light,DALI led power supply, DALI systems. With these, you can control all of the led panels in the building.
