Half power Emergency Dimmable LED Panel Light

TECHNICAL SPECIFICATIONS

PRODUCT SPECIFICATION OF PANEL LIGHTS

※ According to the different permutation and combination way to assemble the several D5000mAh1.2V Ni-MH battery together; 
※ The customer should charge the battery with the little current for a long time ,because the Ni-MH battery is with the better charging ,discharging ,resistance to low and high temperature ,lifetime , safety and storage ,it is the first choice for the emergency battery; 
※ Because Ni-MH battery is with the bigger capacity , smooth discharge ,wide universality,and less heat ,it is one of the most popular green environmental protection battery;
※ It will be better for the battery when you charge the battery before it is fully discharge; 
※ After the group of Ni-MH 12.0VD5000mAh fully discharge , The customer should charge the battery for more than 48 hours to ensure the battery with the full power and the inverter is of the function of charging protection .It can ensure the less damage to the battery when charge .After the battery was fully charging ,it should charge the battery with the little current to supply the self-discharge of the battery; 
※ Driver and battery can resist the high temperature ,it can work in -20~60 ℃; 
※ Taking the application into the consideration ,it would be better for the user to check the battery at regular intervals ,and it must change the battery after 3 years;
※ The warranty of the battery material is 2 years ,it can meet the standard of international IEC61951-2003 ,the cycle lifetime is over 500 period Emergency Panel Lights;
※ Please pay attention the safety when use the battery .Please not disassemble the battery or short the circuit or put the battery into the water or fire to avoid the peril.

ELECTRICAL CONNECTION

LED EMERGENCY POWER SUPPLY INSTALLATION INSTRUCTION

1: accordance with writing diagram to connect the circuit in strict. The following lines are connected to each port;

Terminal 1—— connect FireWire L+ LED external drive firewire input. This line can set a wall switch S. The wall switch only controls the main power, no function on emergency lighting.
Terminal 2—— connect the zero line N+LED external drive zero line input.
Terminal 3——one line connect with the other side of wall switch S, enter the fire wire 1port; one line connect with LED drive’s firewire.
Terminal 4—— connect LED drive’s output positive.
Terminal 5—— connect light source’s negative +light source external drive’s output negative.
Terminal 6——light positive Diagram wiring, all lines and accessories connected to complete before connecting to the mains test, non-live working.

2: Emergency power supply can not no-load, whether it is testing emergency lighting function or testing the inverter charging function, must be process under load light source;
3: Main power line: fire line L and zero line N, connect to main power line directly, these two lines are forbidden to connect the switch;
4: Not control by switch S after the light source start emergency lighting;
5: Green indicator: main power; Red indicator: charging; yellow: falut;
6: no indicator works in emergency status except emergency lighting;

MAINTENANCE

Emergency movement is the core device which controls the battery charge or discharge and start the lighting when under emergency must ensure the wiring is correct. After under normal use, need to discharge once every three months for battery conservation and extend the battery life. Emergency lighting power installed and put into use, need to regularly check, maintain, examine and repair when discover the abnormal condition, or inform the supplier to deal with.

EMERGENCY POWER LED PANEL LIGHT DESCRIPTION

Facroty direct saleemergency led panel lights, which is composed of the led panel light and the no harmful Ni-MH rechargeable battery, it can light for 2-3 hours when there is a power failure.